YOUR SOURCE FOR TOYOTA 22RE PERFORMANCE ENGINES, CYLINDER HEADS, PARTS AND CUSTOM RACING MACHINE WORK
Call us at 530.892.1451 or e-mail info@22reperformance.commailto:info@22reperformance.com?subject=mailto:info@22reperformance.com?subject=info,%20please...shapeimage_2_link_0
22REPERFORMANCE.COM
40 Rash Lane Chico, CA 95973
530.892.1451
Check out our videos and subscribe to our channel. New videos are always being added.
We have done the research to find the best possible parts you will need for a proper and professional installation. The parts we have chosen to sell are from the manufacturers that sell to Toyota themselves, and some of the items are even better than you can find from your local Toyota dealer. We recommend all of the parts below when installing your engine, even if you don’t buy the engine from us.
NGK  Spark Plugs
 
We use ONLY factory recommended spark plugs. We’ve found the platinum and the other gimmicky plugs are a poor choice (they foul too easily) and are a waste since they were not designed SPECIFICALLY for your 22RE/22R.
 
available for all years. We will send the proper heat range and gap for your year specific and model
$10.00 for a set of 4
OEM Distributor Cap and Rotor
 
YEC, Daiichi and ND are the OE manufacturers for Toyota. NO ONE can match the quality of these OEM parts. “Chain store” ignition parts can create more problems than they solve. No matter if you buy them for us or not, we will always recommend OEM ignition parts for quality and longevity.
THERE IS A DIFFERENCE!
85-late 07/92’ cap and rotor kit $20.00
08/92’-95’ (not pictured) cap and rotor kit $22.00
OEM Thermostat
 
Arguably the most important part of your cooling system. Aftermarket parts store thermostats are sold by flange SIZE, not by application. We only sell t-stats that are made by Toyota’s OEM (Kuzeh). These are engineered specific for your Toyota 22RE/22R. Your electronic engine controls depend on PROPER engine temperature regulation to make the engine run at it’s peak performance.
$15.00
Rebuilt OE carburetor (direct replacement)
We have been using the same carb builder for over 15 years and have installed them on our own vehicles. Fully rebuilt including new throttle shaft bushings, needle, seat, floats and all internal o-rings and gaskets.
Includes installation gaskets.
 
(available for any year Toyota truck 1978-1990)
$265.00 (+$75 refundable core deposit) We are also an Authorized Weber dealer. See our Performance Parts page for 
more information
 
OES Toyota ignition wire set
 
Toyota makes the BEST spark plug wires you can buy. DO NOT settle for less. Ignition parts are a lot more crucial than people think. When we do installations, we will NOT install anything but factory wires. We recommend the same for your engine. Long lasting, proper fit (includes loom clips and hangers). They fit right and last longer than any other wire set on the market.
 
81 thru 07/92’ wire set $70.00
(still sourcing 08/92 and later- stay tuned)
Oil pressure switch
 
You NEVER want to re-use your oil pressure switch. If you’ve had any type of engine failure it is contaminated. Cheap insurance, always recommended.
Start with a known-good switch. It could save your engine!
Best quality, Italian built.
79’ - 95’ (with an “oil pressure” warning light)
$5.80
PCV valve and PCV grommet set
 
Japanese built Sankei (Toyota OEM) PCV valve and grommet. Always recommended during any installation / tune. A worn PCV valve and hardened / leaking grommet can lead to a vacuum leak and a rough idle (or worse).
$9.50 (all years and models)
Rebuilt, balanced and flow tested fuel injector set
No matter the year of your 22RE, these injectors will benefit your engine.
Injectors are fully disassembled, ultrasonic cleaned, internal screen filters are replaced along with all new seals (both of the upper, cushion and lower) and new pintle caps are installed.
All 4 injectors are then balanced and flow tested.
We include the flow testing and balance print-out with each set of injectors.
(for all years and models 1984-1995)
$150.00 + exchange
NEW O.E.M.Toyota exhaust manifold stud and nut kit
Due to the countless number of heat cycles yours have been through, it makes the studs incredibly brittle. The last thing you need when installing a new head, engine or head is to break a stud during install.
Our kit includes all 8 studs (4 long and 4 short), copper coated steel nuts and stainless steel washers
ALWAYS RECOMMENDED
$40.00 for the kit
Temperature sending unit
 
Japanese built Sankei (Toyota OEM) temp sender unit for the gauge on the dash. If you buy one of our manifold/plenum kits or if you are just installing a rebuilt engine, it’s best to start with a new unit to keep you updated on the running temp of your engine.
$9.50 (all years and models)
IGNITION PARTS / ENGINE ELECTRICAL
FUEL INJECTION / CARBURETION
COOLING SYSTEM
Radiator hose kit (with clamps)
 
We sell only the best hoses available. Our kit includes the upper, lower and even the hard to find ‘mid’ hose (from timing cover to metal pipe on the engine side).
These hoses are a direct fit and and the upper hose has the ‘anti-abrasion’ guard built on.
Includes 6 stainless steel USA made hose clamps.
 
Available for all years and models of Toyota trucks.
$45.00 for the kit
MISC.
Brake and clutch pedal pads
 
High quality Japanese made rubber pedal pads. Yours are worn or missing, right?
 
$10.00 set (all years and models)
Rebuilt Engines Performance Cylinder Heads 22RE Performance Parts 22RE build process Installation Parts / Kits